MGM TMM 6018-3 EXPERT+ speedcontroller

MGM TMM 6018-3 EXPERT+ is the user-friendly and yet feature-packed speedcontroller. You can use the speedcontroller using the BASIC mode that allows you to select BRAKE/NO BRAKE option. The programming of this speedcontroller can be done using the transmitter, programming card-UNICARD or using your PC.

Specifications of TMM 9044-3 EXPERT+:

• Dimension: 50x31x15mm
• Weight:55g

Features of TMM Controllers:

• Perfect masking of signal interference and losses
• Extremely fine throttle steps (1023 steps)
• Very soft starts
• Motor and controller overload protection
• Built-in protection and management of Lipo/Lion and Nicad/Nimh batteries
• Data measured in operation of the speedcontroller (obtained using PC) (Optional cable and USBCOM required)
• Easy programming of speedcontroller using transmitter, UNICARD card or using PC (Optional cable and USBCOM required)
• S-BEC or switched BEC allows receiver to draw high current even from higher input voltage.

TMM speedcontrollers are also protected in the following ways:

1. Automatic Current Fuse (ACF) reduces the possibility of current overload from damaging the speedcontroller
2. Intelligent Power Reduce (IPR) system reduces the over-discharge of cells through measurement of voltage, current,
   speedcontroller and battery condition
3. IPR system also enables retaining defined energy for BEC in the speedcontroller preventing battery from being
   completely drained during operation (and avoid crashes due to loss of signal from the receiver) - only in speedcontroller
   wtih BEC
4. Automatic Current Reduce (ACR)
5. Thermal fuse protects the speedcontroller up to 90 degrees C.

Also see:
 USBCOM+ PC Interface Module - For connecting ESC, Balancing Charger of Blackbox to PC

CC_02 - Service Connecting Cable

 UNICARD - Programming card for MGM TMM speedcontroller for brushless motor